HiTEC® 580

Specification and Distribution Additive
Текущее наличие в регионе Europe, Middle East, Africa, India (EMEAI) Latin America North America
Чтобы узнать о наличии в других регионах или получить дополнительную информацию, свяжитесь со своим представителем Afton.
Загрузить лист технических данных продукта Запросить паспорт безопасности

Key Performance Benefits

  • Wide military approval
  • Approved for DEF STAN 91-91 use and listed in QPL 68-251
  • Commercial aircraft engine approvals including General Electric, Pratt & Whitney, Rolls Royce & Allison
  • More detailed approval list available on request
  • Suitable in pipelines designed for the transportation of light petroleum products
  • Minimises corrosion and formation of corrosion products
  • Minimises risk of pipeline filter and pump blockages due to products of corrosion
  • Good low temperature properties and relatively high flash point permitting ease and safety of application
  • Provides lubricity protection for light distillate
  • Protects against catastrophic failure caused by excessive wear
  • Reduces corrosion

Application

HiTEC® 580 is an industry recognised corrosion inhibitor and lubricity improver designed and approved for use in jet fuel, pipeline applications and stationary gas turbines.

Typical Characteristics

Handling Information

Max Handling Temp: 40˚C (102°F)
Shelf Life: Please refer to your supplied Certificate of Analysis or consult your local Afton representative

Recommended Dosage

HiTEC® 580 additive is approved for jet fuel specifications at a minimum treat-rate of 15mg/l and a maximum of 23mg/l.

The treat-rate for HiTEC® 580 additive as a corrosion inhibitor will vary based upon its use. When used in a pipeline as a first fill an initial treat-rate 22.5 g/m3 is recommended, followed by continuous treatment at a dosage of 6–9 g/m3.

HiTEC® 580 additive should be used in stationary gas turbines at a treat-rate of 150µl/l to provide maximum protection.